AccuAir 3/8" DOT/PTC × 3/8" DOT/PTC Bulkhead Fitting Q70L Allows for slight lift

Allows for slight lift

1991 Mitsubishi 3000GT

Part Number ISC-N002-S Part Name N1 V2 Street Sport Coilovers Vehicle 1995-1999 Nissan Sentra Chassis Code B14 Spring Rates - Front 8 kg/mm Spring Rates - Rear 6 kg/mm Spring Length - Front 180mm Spring Length - Rear 180mm Triple S Coilover Springs Upgrade Yes Top Mounts - Front Pillowball top plates or adjustable camber plates when applicable or re-use OE strut/shock mounts Top Mounts - Rear Factory like rubber top plates or re-use OE strut/shock mounts Ride-Height Adjustable Yes Damping Adjustment 1-Way Quantity Full Set (Front & Rear) Vehicle Fitment

The KSport Version DR Drag Race Coilover Kit is purpose-built to launch the 2015-2018 Subaru WRX harder and straighter

Whiteline's heavy duty (off car) Adjustable Panhard Rods to your 1990-1997 Toyota Land Cruiser Base (J80) are a must have for raised vehicles to reset axle location and wheel alignment rectification

AccuAir 3/8" DOT/PTC × 3/8" DOT/PTC Bulkhead Fitting Q70L Allows for slight liftA dual 3 8" push to connect bulkhead fitting for passing airline cleanly through a panel, floor, or firewall. Sealed flange with locking nut. AccuAir ships every fitting, harness, and hardware piece through their factory match supply chain, so the part you receive is the exact same revision AccuAir uses on a new ENDO VT or VU4 build. Correct material, correct seal geometry, correct thread no third party ambiguity. Specifications Part Number AA 3659