DC Barrel Jack Adapter - Male > $1000 The secondary load center include

The secondary load center include ten 20-amp

LM-30-3S-4X400W-LED-EW Three Stage LED Light Tower Mast Summary Lamp Type: Bridgelux® LED 12 to 30 Foot Light Mast Lamps: (4) 480 Watt LED Fixtures Steel Construction Total Watts: 1920 (480W per lamp) Power Coated Finish Total Lumens: 259

the motor power and servo power rail can be connected to the Arduino's regulated voltage

There is also a 'SYS OUT' with a pre-installed JST connector which allows you to connect the charging circuit directly to your project so you don't need to disconnect the charger each time you want to use it

000 Hours Operating Temp Rating: T5 Factory Sealed Light Fixture Housing Material: Copper Free Cast Aluminum Recommended 15` to 40` Mounting Height Housing Finish: Epoxy Powder Coated - Grey Lens Material: Hardened Borosilicate Glass Gasket Material: Silicone Toll Free: 1-800-369-6671 Mounting: 3/4" Pendant Intl: 1-214-616-6180 Wiring: 10` 16/3 SOOW w/ Flying Leads Fax: 1-903-498-3364 Wiring Hubs: (4) 3/4" NPT Threaded Hubs E-mail:Â

DC Barrel Jack Adapter - Male > $1000 The secondary load center includeThis adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5. 5x2. 1mm, center positive male barrel jack. If you need to connect bare wires to a barrel jack on an Arduino or a development board, this might be the simple solution. Please be aware that the max current for this adapter is 10A.